THE STUDY EXPERIMENTAL CHARACTERISTICS OF THE DRIVE CONE INSTALLATION TRIBOSYSTEM SWEDISH COMPANY KAMYR

G. I. Kamel, P. S. Ivchenko, L. M. Martovitskij, Yu. A. Gasilo, Yu. M. Savonov, N. S. Kotlyarov

Abstract


The influence on the reliability, service life and suitable for repair p-tutela conical tribological system the following operating and design parameters: the magnitude of the gap in the feeder at the compensation level solace in the feed pipe, the amplitude of the oscillations of the rotor by the action of water hammer, the amplitude of the axial movement of the rotor in the compensation gap, especially wear of the mating parts of the feeder. Stated that 80% of the surface of the parts feeder conical tribosystem perform functions, as is the boot and shut-off devices. 20% provide rigidity and strength of frame of the feeder and provide Autonomous operation of the two conical sections of the tribological system. Define a rational and constructive process option, and operation of mating parts tapered tribosystem Swedish company Kamyr.


Keywords


conical tribosystem; rotary feeder; actuator; gap compensation; operating mode; the amplitude of the vibrations; hammering; pH alkali; wear; work offline; sections of the feeder; loading

References


Камель Г.И. Роторные питатели установок непрерывной варки целлюлозы / Камель Г.И. – М.: Лесная промышленность, 1987. – 160с.

Нечаев Г.И. Повышение надежности и продуктивности загрузочных устройств непрерывной варки целлюлозы и полуцеллюлозы: монография / Г.И.Нечаев, Г.И.Камель. – Луганск: Изд-во СНУ им. В.Даля, 2005. – 392с.

Дослідження конічних трибосполучень у промисловому транспорті: монографія / Г.І.Камель, В.В.Перемітько, А.В.Єршов, Р.А.Куліковський. – Дніпродзержинськ: ДДТУ, 2013. – 313с.


Refbacks

  • There are currently no refbacks.


Copyright (c) 2018 Collection of scholarly papers of Dniprovsk State Technical University (Technical Sciences)

ISSN (print) 2519-2884

ISSN (online) 2617-8389