FORM THE GENERATOR OF THE ROTATING PARTS WITH INTERSECTING AXES OF THE PART AND GRINDING WHEEL

I. V. Belmas, I. T. Bobyleva, I. Yu. Soromitko

Abstract


The influence of the mutual location of the axes of the parts rotation of the grinding wheel and its diameter on the surface of a type of hyperboloid of rotation with a single cavity and close to its surface. An algorithm is proposed which allows to determine the mutual arrangement of the elements of the kinematical method of grinding a curved symmetrical profile with three geometric parameters of the grooves including grooves of inner ring of rolling bearings than to improve the accuracy of formation of these surfaces.


Keywords


grinding; kinematical method for forming the annular groove; the groove diameter; the diameter of the grinding wheel; the skew axis

References


Пат. 110324 Україна, МПК B24B 5/04. Спосіб шліфування деталей обертання / Бельмас І.В., Танцура Г.І., Білоус О.І., Танцура Т.О.; заявник та патентовласник Дніпродзерж. держ. техн. унів-т. – № 110324; заявл. 04.03.16; опубл. 10.10.16, Бюл. №19/2016.

Радзевич С.П.Формообразование поверхностей деталей (Основы теории) / Радзевич С.П. – К.: Ростан, 2001. – 592с.


Refbacks

  • There are currently no refbacks.


Copyright (c) 2018 Collection of scholarly papers of Dniprovsk State Technical University (Technical Sciences)

ISSN (print) 2519-2884

ISSN (online) 2617-8389